Gto Wireless Exit Sensors GTO Manual do Utilizador descarregar pdf (Página 5)

Wireless Exit Sensor

GTO WIRELESS EXIT WAND

TRANSMITTER

CODE

MED

TRANSMIT

ACTIVE

MIN MAX

SENSITIVITY

NOTE: The module should extend out

at least 12” above ground.

• InstallandconnecttheRB709U-NBreceivertoyourgateoperatorasshownintheinstructionssuppliedwith 

 thatreceiver.YoucanskipthisstepifyouhaveaGTOGEN3controlboardonyourgateoperator.

• IfusingtheRB709U-NBreceiver,itisrecommendedthatyoudisconnecttheoriginalantennareceiverthat 

 camewithyourgateopener.

• RemovetheoutercoverfromtheElectronics/TransmitterModule.

• SetthetransmitterDipSwitches.IfyouhaveGTOhandheldtransmittersforyourgate,settheDipSwitchesin

 theTransmitter/ModuletothesamesettingsastheDipSwitchesinyourtransmitter.IfyoudonothaveGTO

 transmitters,settheDipSwitchestoanydesiredsetting.Wedonotrecommendusingthefactorycode 

 settingasshipped.

• Setthesensitivitycontroltomidscale(mediumsensitivity).

• DONOTinstallthebatteriesatthistime!

GTO WIRELESS EXIT WAND

TRANSMITTER

CODE

MED

TRANSMIT

ACTIVE

MIN MAX

SENSITIVITY

Sensitivity

Potentiometer

Dip Switches

Transmit Indicator

• SecuretheElectronics/TransmitterModuleon

 thesuppliedPVCpipebyburyingthebottomthird

 ofthepipeinthesoilandtampingtheground

 aroundthepipe.DONOTcovertheelectronics

 modulewithametalcoverasthiswillcause

 signalinterference.

• Thiscompletesthehardwareinstallation.

Electronics/Transmitter Module Setup

Planting the Electronics/Transmitter Module

1 2 3 4 5 6 7 8 9

Sem comentários

Gto Wireless Exit Sensors GTO Manual do Utilizador Página 5